Operation CHARM: Car repair manuals for everyone.

Pressure Regulator Bushing Spring Pin - Revised

Model Year 1983

Bulletin No. 83-219

File In Group 70

Number 44

Date Jan. '84
SUBJECT: PRESSURE REGULATOR BUSHING SPRING PIN

MODELS AFFECTED: 1983 THM 325-4L TRANSMISSION - ALL MODELS

FIGURE 1:




FIGURE 2:




Beginning in April 1983, a new solid pin for the pressure regulator bushing went into production for all THM 325-4L transmissions. The purpose of the new pin is to eliminate the possibility of distorting the case face during assembly. The new solid pin is larger in diameter than the coiled spring pin, therefore, the two pins must not be used interchangeably. (See Figures 1 & 2).

NOTICE: The new pin is a slip fit in the transmission case. If the transmission is rolled over, the pin may fall out, allowing the pressure regulator bushing to lose proper orientation.

If replacement of either design pin is required, use the following numbers to order the correct pin:

Fig.. 1 - Solid Pin - Part Number 141202 Fig. 2 - Coiled Spring Pin - Part Number 9437415