Distributor Vacuum Control: Description and Operation
SPARK CONTROL
Beginning in 1970, several models use vacuum operated systems to modify ignition timing, and spark advance. Some of these systems are temperature sensitive, and some are electrically controlled.
Vehicles equipped with spark control systems use distributor vacuum diaphragm units of three basic types: advance/retard, advance only and retard only. The number and type of the control devices in the vacuum system varies with the type of system.
Simple retard only systems are controlled by manifold vacuum alone. When vacuum is high, (as at idle or on deceleration) timing is retarded. When vacuum is low, normal centrifugal advance takes over. This type of system is used on both 4 and 6 cylinder engines.
Some 2002 models are equipped with an advance only system that is designed to operate only below a specified temperature. An electronic temperature sensor activates a vacuum switching valve, allowing vacuum advance to be applied until the engine nears operating temperature. Above 149~, the system shuts down.
Some 4 cylinder models, such as 320i, use a combination system, with an advance/retard diaphragm. This system has a retard vacuum circuit controlled by a thermo timing valve, which prevents retard during engine warm-up. There is also an advance vacuum circuit, which is controlled by a thermo valve (vacuum switch sensing coolant temperature), applying advance during engine warm-up. After warm-up, advance switches off, and retard is applied during periods of high vacuum.
Speed sensitive systems are also used, often in conjunction with other emissions systems. Speed sensitive types use an RPM switch to monitor engine speed, and supply or stop advance or retard vacuum flow by means of a vacuum switching valve. These systems are found on several models, and vary slightly by year and local requirements. They can also be temperature sensitive.