Cover Profile

Cover Profile






1 - Windshield

• Removed.

2 - Cover profile

• Before installing new cover profile, remove residue completely using a commercially available window scraper.

• Clean adhesion area with cleaning solution D 009 401 04.

• Apply on to interior of window using, for example, a soft pencil at a distance - a - = 8 mm from upper window edge.

• Prime adhesion surface with D 009 200 02 up to marking applied earlier and let it air dry for at least 10 minutes.

• Press cover profile onto window centered with rear edge to end of priming (pencil marking).

• Press on cover profile firmly using an application roller.

• Reinstall window.

Cover Profile, Adhering

- Windshield - 1 - with ceramic coating.

- If cover profile is damaged, remove rest of profile completely using a glass scraper without damaging ceramic coating printed area.

- Clean adhesion area with cleaning solution D 009 041 04.

- Now apply a marking at uniform distance - a - = 8 mm to top of window edge.






- Apply primer D 009 200 02 cleanly up to marking.

- Allow primer to air dry for at least 10 minutes.

- Remove protective foil from double-sided adhesive tape - 2 - for side impact molding.

- Place cover profile - 3 - onto window centered with rear edge to end of priming (marking).

- Press on profile firmly onto window using a application roller.