Operation CHARM: Car repair manuals for everyone.

0AW Continuously Variable Transmission






Dual-Mass Flywheel Overview






1 Dual Mass Flywheel

• Removing and installing, refer to => [ Dual Mass Flywheel ] 0AW Continuously Variable Transmission

2 Transmission Housing

3 Input Shaft Seal

• Removing and installing, refer to => [ Input Shaft Seal ] Input Shaft Seal

4 Bolt

• Replace

• Quantity: three for 4-cylinder engines

• Quantity: 6 for 6-cylinder engines






Tighten the dual-mass flywheel to the drive plate as follows:






- Install the first bolt - arrow - and tighten by hand (2 Nm).

Vehicles with 4 Cylinder TFSI 2.0L Engine






- Continue turning the crankshaft on the vibration damper 240° in direction of engine rotation using the (T10355).

- With the crankshaft in this position, tighten the bolt - arrow - to 60 Nm.






- Continue turning the crankshaft 120° and tighten the remaining 2 bolts to the tightening specification.

Vehicles with 6-Cylinder Engine






- Insert the (T40058) guide pins as follows:

• The large diameter - arrow 1 - faces the engine.

• The small diameter - arrow 2 - faces the adapter.

- Continue turning the crankshaft on the vibration damper 180° in the direction of the engine rotation using the (T40058) - arrow -.






- With the crankshaft in this position, tighten the bolt to 60 Nm.






- Continue turning the crankshaft 60° and tighten the remaining 5 bolts to the tightening specification.