0AW Continuously Variable Transmission
Dual-Mass Flywheel Overview
1 Dual Mass Flywheel
• Removing and installing, refer to => [ Dual Mass Flywheel ] 0AW Continuously Variable Transmission
2 Transmission Housing
3 Input Shaft Seal
• Removing and installing, refer to => [ Input Shaft Seal ] Input Shaft Seal
4 Bolt
• Replace
• Quantity: three for 4-cylinder engines
• Quantity: 6 for 6-cylinder engines
Tighten the dual-mass flywheel to the drive plate as follows:
- Install the first bolt - arrow - and tighten by hand (2 Nm).
Vehicles with 4 Cylinder TFSI 2.0L Engine
- Continue turning the crankshaft on the vibration damper 240° in direction of engine rotation using the (T10355).
- With the crankshaft in this position, tighten the bolt - arrow - to 60 Nm.
- Continue turning the crankshaft 120° and tighten the remaining 2 bolts to the tightening specification.
Vehicles with 6-Cylinder Engine
- Insert the (T40058) guide pins as follows:
• The large diameter - arrow 1 - faces the engine.
• The small diameter - arrow 2 - faces the adapter.
- Continue turning the crankshaft on the vibration damper 180° in the direction of the engine rotation using the (T40058) - arrow -.
- With the crankshaft in this position, tighten the bolt to 60 Nm.
- Continue turning the crankshaft 60° and tighten the remaining 5 bolts to the tightening specification.