Operation CHARM: Car repair manuals for everyone.

Cylinder Head, Valvetrain - Fastener Tightening Specifications






Fastener Tightening Specifications






Timing Chain Upper Cover - Tightening Sequence

- Tighten the bolts - 1 through 5 - in the sequence shown:






- Tighten the bolts to 9 Nm.

Timing Chain Lower Cover Tightening Sequence

- Tighten the bolts - 1 through 15 - in 2 stages in the sequence shown:






- 1. Tighten the bolts to 8 Nm.

- 2. Tighten the bolts an additional 45°.

Intermediate Shaft Sprocket Tightening Sequence






Always replace the intermediate shaft sprocket. Otherwise the backlash will not adjust itself and it could result in engine damage.

The new intermediate shaft sprocket has an anti-friction coating that wears off after a short period of use, which automatically adjusts the backlash.

- Tighten with a new bolt as follows:

1. Tighten to 10 Nm using a torque wrench.

2. Rotate the intermediate shaft sprocket.

The intermediate shaft sprocket must not have any play. Loosen and tighten it again if necessary.

3. Tighten to 25 Nm using a torque wrench.

4. Tighten further 90° using a rigid wrench.

Loosening the Cylinder Head

- Remove the bolts - arrows -.






- Loosen the cylinder head bolts in sequence - 1 to 10 -

Cylinder Head Tightening Sequence

- Tighten the cylinder head bolts in - 1 to 10 - sequence.






1. Tighten to 40 Nm using a torque wrench.

2. Tighten further 90° using a rigid wrench.

3. Tighten further 90° using a rigid wrench.

4. Tighten the bolts - arrows - to 8 Nm.

5. Tighten the bolts - arrows - 90° further using a rigid wrench.

Loosening the Cylinder Head Cover

- Loosen the cylinder head cover in a 1 to 6 sequence.






Cylinder Head Cover Tightening Sequence

- Replace the bolts.

1. Hand-tighten bolts in several stages in sequence - 1 to 6 -.






2. Tighten the bolts in sequence - 1 to 6 - to 8 Nm using a torque wrench.

3. Tighten the bolts an additional 90° using a rigid wrench in the sequence - 1 to 6 -