Operation CHARM: Car repair manuals for everyone.

Oxygen Sensor: Description and Operation






Oxygen Sensor Overview

Heated Oxygen Sensor





1 Heated Oxygen Sensor (HO2S) (G39) and Oxygen Sensor (O2S) heater (Z19)
2 Connector for HO2S

Heated Oxygen Sensor





1 Connector for O2S after Three Way Catalytic Converter (TWC) (G130)
2 O2S after TWC (G130) and heater for O2S 1 after catalytic converter (Z29)

• Tightening Specifications: 55 Nm

• New oxygen sensors are coated with assembly paste; the paste must not get into slots of oxygen sensor body.

• For a used oxygen sensor, only coat threads with hot bolt paste. This paste must not come into contact with oxygen sensor slots. Hot bolt paste, refer to the Parts Catalog.

• Always install the oxygen sensor wire in the same location so it does not come into contact with the exhaust pipe.

HO2S (G39) and O2S Heater (Z19) , Removing and installing, refer to => [ Heated Oxygen Sensor (G39) and Oxygen Sensor Heater (Z19) ] Heated Oxygen Sensor (G39) and Oxygen Sensor Heater (Z19).

O2S after TWC (G130) and O2S 1 Heater (Z29) , removing and installing, refer to=> [ Oxygen Sensor after Three Way Catalytic Converter (G130) and Heater for Oxygen Sensor 1 after Catalytic Converter (Z29) ] Oxygen Sensor After Three Way Catalytic Converter (G130) and Heater For Oxygen Sensor 1 After Catalytic Converter (Z29).