Operation CHARM: Car repair manuals for everyone.

Windshield Wiper System, Removing and Installing



Windshield Wiper System, Removing And Installing

NOTE: Control module for wiper motor -J400- is integrated into wiper motor.

Special tools and workshop equipment required







- Extractor T10130

Removing
- When replacing wiper motor with Control module for wiper motor -J400-, select "Replacement" function for control module for wiper motor in "Guided Fault-Finding" routine.
- VAS 5051 Vehicle Diagnostic Testing and Information System must be used for this purpose.







- Remove rubber seal -1- of plenum chamber cover.
- Remove plenum chamber covers -2- and -3-.
- Remove dust and pollen filter.

NOTE: Cover air duct at air conditioner housing with clean cloth to stop anything falling in.

Wiper arms, removing
- Switch on ignition.
- Actuate flick wipe function and allow wiper arms to move to end position.

CAUTION:
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.

- Use screwdriver to pry off caps at wiper arms and remove hex nuts.







- Remove wiper arm from shaft using extractor T10130 and remove.