Procedures

Leak Detection Pump (LDP) -V144-, Removing And Installing

Removing
- Remove left rear wheel.
- Remove wheel housing liner, rear left.







- Disconnect hose connections -1-, -5- and -6- at vent lines.
- Remove securing bolts -2- and -3-.
- Remove Leak Detection Pump (LDP), disengage harness connector for electrical wire -4- with ignition off and disconnect.

Installing
Installation is the reverse of removal, noting the following

NOTE: Secure all hose connections using hose clamps appropriate for the model type

Tightening torque

Component Nm
Leak Detection Pump (LDP)
bracket to wheel housing 8