Operation CHARM: Car repair manuals for everyone.

Intake Manifold Change-Over Valve -N156-, Checking




Intake Manifold Change-Over Valve -N156-, Checking

- Let vehicle run at idle for 2 to 3 minutes (vacuum build-up).
- Switch off engine.
- Switch ignition on.
- Perform Output Diagnostic Test Mode (DTM) and activate intake manifold change-over valves. Refer to Scan Tool Testing/Output Diagnostic Test Mode (DTM) (Function 03) Testing and Inspection

Indicated on display:


Output Diagnostic Test Mode (DTM) ->
Intake manifold change-over valve -N156


Solenoid valve must click (by touch or audibly). Output Diagnostic Test Mode (DTM) will be aborted after one minute.

- Solenoid valve does not click.
- Switch ignition off.
- Disconnect connector from solenoid valve for intake manifold change-over.







- Perform a resistance measurement between the solenoid valve terminals using VAG1526.

Specification: 25 to 35 Ohm

- If the specified value is not reached, replace intake manifold change-over valve.

If the specified value is obtained, check voltage supply.

Checking voltage supply of intake manifold change-over valve







- Connect VAG1527B voltage tester to connector socket 1 and engine Ground (GND) using adapter cables from VAG1594 connector test kit.
- Operate starter briefly.

LED must light up.
- LED does not light up.
- Check fuse for intake manifold change-over valve.

Voltage supply is OK.

- Wire connection from connector socket 1 via fuse for intake manifold change-over valve to fuel pump relay for open circuit or short circuit.

If the voltage supply is OK, check activation.

- Re-install fuel pump relay and fuse.

Checking activation of intake manifold change-over valve
- Connect VAG1527B voltage tester using cables from VAG1594 connector test kit to sockets 1 (B+) and 2 of connector to intake manifold change-over valve.
- Perform output Diagnostic Test Mode (DTM) and activate the respective intake manifold change-over valve. Refer to Scan Tool Testing/Output Diagnostic Test Mode (DTM) (Function 03) Testing and Inspection

Indicated on display:

Output Diagnostic Test Mode (DTM) ->
Intake manifold change-over valve -N156


If LED does not blink or if it remains constantly lit. Check wire connection.

Checking wire connection
- Connect VAG1598/31 test box at wiring harness to Engine Control Module (ECM), do not connect ECM. Refer to "Scan Tool Testing/Scan Tool Connecting and Initial Checks/Connecting VAG1598/31 Test Box" Testing and Inspection







The following wire connections must be checked for short circuit to B+, Ground (GND) and for open circuit

Connector for VAG1598/31 test
intake manifold box socket
change-over valve
-N156- Socket

2 -

Wire resistance: max: 1.5 Ohm

- If the wire connection is OK, replace Engine Control Module (ECM).
- Check intake manifold change-over once again for function.