Operation CHARM: Car repair manuals for everyone.

Alternator: Service and Repair




Generator, Removing and Installing

Vehicles With 3.0 L 6-cylinder Engine

Read caution before beginning repairs on the electrical system.


- Note and if necessary, determine radio code for vehicles equipped with coded anti-theft radio / radio navigation system only foreign brands).
- Switch ignition off and disconnect battery Ground (GND) strap.


NOTE: See Battery, Disconnecting and Connecting procedure for the steps after reconnecting voltage supply.


Special tools and equipment







- 3299 ribbed belt installation tool with 3299/1 claw for tensioner

Removing







- Remove front engine cover -arrows-.


NOTE: Before removing ribbed belt, mark direction of rotation with chalk or felt-tip marker. Reversing the direction can destroy the belt.







- Move ribbed belt tensioner in direction of arrow to release tension on ribbed belt.
- Remove ribbed belt from power steering pump pulley.







- For vehicles with auxiliary heater, remove bolts -arrows- for exhaust pipe of stationary heater/auxiliary heater on noise insulation.







- Remove bolts or quick release screws -1- and -2- and remove front noise insulation.







- Cut cable ties -arrows-, open retainer for starter cable and remove cable.

Vehicles With Automatic Transmission







- Remove bracket for ATF lines, by unscrewing nuts -1- and -2-.

All:
- Unclip refrigerant line from bracket at oil pan.
- Disconnect electrical lines from generator.







- Remove bolts -arrows- and generator.

Installing
Installation is reverse order of removal, pay attention to the following:







- Make sure the ribbed belt is seated and installed correctly.
1 - Generator
2 - Ribbed belt
3 - Power steering vane pump
4 - A/C compressor
5 - Crankshaft
6 - Tensioner roller
- Start engine and check belt running.

Tightening torques
Generator to engine (M8): 22 Nm
Generator to engine (M10): 45 Nm
Terminal 30/B+ to generator: 16 Nm
Bracket for refrigerant line to oil pan: 10 Nm
Bracket for starter wire to engine console: 10 Nm