Oil Filter: Service and Repair
Part II - Oil filter bracket components
1. Screw plug - 40 Nm
2. Sealing ring
^ Always replace
3. Spring
^ For pressure relief valve, approximately 4 bar
4. Piston
^ For pressure relief valve, approximately 4 bar
5. Gasket
^ Always replace
6. Oil retention valve
^ Tighten to 8 Nm
^ Built into oil filter bracket
7. O-ring
^ Always replace
^ Slide on until flush with collar on pipe -Item 9-
8. Locking clip
9. Pipe
^ For crankcase breather
10. 20 Nm
^ Install with locking fluid D 000 600 A2
11. Bottom coolant pipe
12. Screw plug - 15 Nm
13. Sealing ring
^ If seal is leaking, cut open and replace
14. Oil supply pipe
^ To turbocharger
15. Banjo bolt - 30 Nm
16. Seals
^ Always replace
17. Oil pressure switch F -1-, 1.4 bar 25 Nm
^ Black insulation
18. Sealing ring
^ If seal is leaking, cut open and replace
19. 15 Nm + 1/4 turn(90°C) further
^ Always replace
20. Gasket
^ Always replace
^ Engage in projections on oil cooler
21. Oil filter
^ Observe change intervals
^ Observe installation instructions on oil filter
^ Tighten to 20 Nm
22. 25 Nm
23. Oil cooler
^ Ensure clearance to adjacent components
^ Coolant hose connection diagram
24. Oil filter bracket
^ With pressure relief valve, approximately 4 bar