Operation CHARM: Car repair manuals for everyone.

Starter Motor: Service and Repair




Starter, Removing And Installing


CAUTION!
Disconnect the battery Ground (GND) strap before working on the electrical system.


NOTE:

- Before disconnecting the battery, determine the correct coding for the anti-theft radio.
- Once the battery is reconnected, check and activate the vehicle's electrical equipment (radio, clock, comfort and convenience features, etc.).


All vehicles

- Start engine and make sure belt runs properly.


Vehicles with 6-cylinder gasoline engines

Removing


NOTE:
To remove the starter, it is first necessary to remove the generator.


2.7 L/184 kW engine, 5V twin-turbo only







- Remove air duct -1-.

2 - Attachment point for oil and refrigerant lines
3 - Engine block mounting point
4 - Hose clamp (loosen)

All vehicles







- Disconnect wire from terminal 30/B+ -2- by removing nut. Tightening torque: 16 Nm (12 ft lb)
- Disconnect harness connector from terminal 50 -2-.

Vehicles with manual transmission







- Remove rear noise insulation panel (arrows) .







- Remove mounting bolts -1- and -2- for starter.
Tightening torque: 65 Nm (48 ft lb)
- Remove starter toward front.

Vehicles with automatic transmission
- Remove right-front wheel.







- Upper bolt -1- can be unscrewed from right-front wheel housing.
Tightening torque: 65 Nm (48 ft lb)
- From engine side, remove lower bolt.
Tightening torque: 65 Nm (48 ft lb)
- Remove starter toward front.

Installing

- Install starter in reverse order of removal.