Operation CHARM: Car repair manuals for everyone.

Front Final Drive, Servicing


Front final drive, servicing

CAUTION! Do not run engine with the oil pan removed or without the ATF flied up and do not tow vehicle.

Note:
^ The parts listed in the following illustration can be removed with the transmission installed.
^ Rules of cleanliness for working on automatic transmission.
^ Repair notes.
^ Coat sealing ring with ATF. Other lubricating substances lead to functional problems in the hydraulic transmission control.





1. Adjustment shim
^ Behind bearing ring
^ Shim size carefully determined and cannot be replaced with just any other.
2. Bearing ring
^ Remove and install by hand
3. O-ring
^ Always replace
^ Coat with transmission fluid
4. Locking screw - 35 Nm
^ For checking gear oil
5. Bolt-25 Nm
^ Conical button
6. Right drive flange
7. Seal
^ For right drive flange
^ Replacing, Refer to Sealing Ring For Right Drive Flange, Replacing.
8. Bolt-23 Nm
^ Note tightening sequence, Refer to Specifications.
9. Differential cover
10. Adjustment - shim
^ Behind bearing ring
^ Shim size carefully determined and cannot be replaced with just any other.
11. Bearing ring
^ Remove and install by hand
12. O-ring
13. Differential
14. Bolt-23 Nm
15. Intermediate flange for front final drive
16. Transfer case
17. Bushing
18. Gasket
19. Roll pin
^ For transmission selector lever during installation drive in from rear to front into transmission selector lever
20. Transmission - selector lever
21. Seal
^ For selector lever shaft
22. Bolt-23 Nm
23. Seal
^ For left drive flange
24. Drive gear
^ For speedometer Vehicle Speed Sensor (VSS) -G22-
25. Left drive flange
26. Mounting bracket for left drive flange
27. Ball bearing for left drive flange
28. Snap ring
^ For ball bearing
29. For left drive flange
^ Square cross section