Compressor (Denso), Removing and Installing

Denso Compressor, Removing And Installing From Bracket (8 Cyl. Engine With A/C Clutch -N25-)


NOTE:
- Compressor bracket from engine, removing and installing.
- Do not discharge the refrigerant circuit. The compressor can be removed without opening refrigerant lines.


- Lock carrier, moving-into service position:







Removing
- Release tension on ribbed belt:
- Remove screws -A- and -B-.


NOTE:
- Do not discharge the refrigerant circuit. The compressor can be removed without opening refrigerant lines.
- On this vehicle the high pressure line is connected on the left side of the condenser, for this observe the following:
-- After removing, fasten compressor (e.g. using wire) to left longmember. Do not let it hang on refrigerant line.
-- For engine removal, after removing lock carrier, attach/fasten compressor together with condenser on right longmember.


Installing
- Observe proper seating of centering pins -C- when installing compressor.
- Tighten bolts -A- and -B- to 25 Nm.