Restrictor - Removing/ Installing

RESTRICTOR, REMOVING/INSTALLING (87-1265)




- discharge A/C refrigerant system 15

- remove evaporator inlet (high pressure) line

- using long nose pliers, remove restrictor from evaporator in let

- install in reverse order of removal noting the following:

- replace O-ring seal -A-

^ O-ring seal:
7.5 mm inside diameter,
1.5 mm thickness

- insert restrictor into evaporator inlet so that arrow on restrictor points towards evaporator

- push restrictor into inlet until fully seated

Note!
Restrictor must fit tight in inlet.