Operation CHARM: Car repair manuals for everyone.

Manual Climate Control





CAUTION:
- All SRS wiring harnesses are covered with yellow outer insulation.
- Before disconnecting any part of the SRS wire harness, install the short connectors.
- Replace the entire affected SRS harness assembly if it has an open circuit or damaged wiring.

1. Remove the radio/cassette unit. Service and Repair

NOTE: The original equipment radio has a coded theft protection circuit. If service to the car requires any of the following, be sure you get the customer's code number before you begin work:
- disconnecting the battery.
- removal of fuse No. 56 (7.5A).
- removal of the radio.
After service, reconnect power to the radio and turn it on. The word "CODE" will be displayed. Enter the customer's 5-digit code to restore radio operation.





2. Remove the screws then disconnect the control unit connectors.
3. Remove the control unit assembly by pushing the clips down as shown.

CAUTION: Be careful not to damage the center console panel and the dashboard.