Operation CHARM: Car repair manuals for everyone.

Intake Manifold Overview






Intake Manifold Overview






1 Intake Manifold Support

2 Bolt

• 20 Nm

3 Bolt

• 10 Nm

4 Gasket

• Always replace

• Ensure it is correctly seated in the intake manifold.

5 Throttle Valve Control Module (J338)

• With the EPC throttle drive, EPC throttle drive angle sensor 1 and EPC throttle drive angle senor 2.

• When replacing, adapt the Engine Control Module (ECM) to the throttle valve control module. Refer to "Guided Functions" in the vehicle diagnostic tester.

• Removing and installing, refer to => [ Throttle Valve Control Module J338 ] Service and Repair.

6 Bolt

• 7 Nm

7 Gasket

• Always replace.

• Ensure it is correctly seated in the intake manifold.

8 Vent Hose

• For the crankcase ventilation.

• With the positive crankcase ventilation heating element.

• From the cylinder head cover.

9 Bolt

• 3.5 Nm

10 Upper Intake Manifold

• With the vacuum actuator and intake manifold flap.

• Intake manifold flap vacuum actuator, checking. Refer to => [ Intake Manifold Flap Vacuum Actuator, Checking ] Testing and Inspection.

• Removing and installing, refer to => [ Upper Intake Manifold ] Upper Intake Manifold.

11 Bolt

• 10 Nm

12 Vacuum Line

Vacuum hose connection diagram. Refer to => [ Vacuum Hose Connection Diagram ] Vacuum Hose Connection Diagram.

Vacuum hose overview. Refer to => [ Vacuum Hose Overview ] Vacuum Hose Overview.

13 Intake Manifold Runner Control Valve (N316)

Vacuum hose connection diagram. Refer to => [ Vacuum Hose Connection Diagram ] Vacuum Hose Connection Diagram.

Vacuum hose overview. Refer to => [ Vacuum Hose Overview ] Vacuum Hose Overview.

14 Fuel Rail

• For cylinders 2, 4 and 6.

• The fuel injector springs - item 18 - in the => [ Fuel Rail with High Pressure Pump and Injectors Overview ] Fuel Rail with High Pressure Pump and Injectors Overview, must be replaced before installation.

• Tighten the bolts uniformly, starting from the inside and working toward the outside.

• Fuel rail with high pressure pump and injectors overview. Refer to => [ Fuel Rail with High Pressure Pump and Injectors Overview ] Fuel Rail with High Pressure Pump and Injectors Overview.

15 Bolt

• 30 Nm + an additional 90° (1/4) turn.

• Always replace.

• Tighten uniformly, starting from the inside and working toward the outside.

16 Bolt

• 3.5 Nm

17 Mounting Plate

• For the coolant hoses.

18 Bolt

• 3.5 Nm

19 Coolant Line

20 Bolt

• 8 Nm

• Quantity: 4

21 Lower Intake Manifold

22 Gasket

• Replace if damaged.

• Coat lightly with engine oil before installing and insert it into the upper intake manifold.

23 Gasket

• Make sure it fits securely inside the lower intake manifold.

24 Intake Manifold Support