Windshield Washer Pump: Service and Repair

Windshield Washer Pump (V5)

The windshield washer pump is located in front of the right front edge and is inserted in the tank for the windshield/headlamp washer system.

• Depending on the equipment, the installation location of the windshield washer pump may deviate slightly from the figures. Removal is identical.

Removal

- Switch off the ignition and all electrical consumers and remove the ignition key.

- Remove the front bumper cover.

• In order to prevent interchanging of the washer fluid line connections at the windshield washer pump, the connections at the pump and the hose lines are color-coded. The hose connections must be connected to the correspondingly colored pump connections during installation.

- To release, turn the securing clips at the hose connections - 3 - and - 5 - and remove from the windshield washer pump (V5) - 4 -.






- Catch any draining fluid in a suitable container.

- Remove the windshield washer pump - 4 - upward out of the tank.

- Release and disconnect the harness connector - 2 - and remove the windshield washer pump.

Installation

Installation is performed in the reverse order of removal. Note the following:

- Bleed the headlamp washer system after conclusion of the assembly steps. Refer to=> [ Headlamp Washer System, Bleeding ] Procedures.