Relay Carrier on Vehicle Electrical System Control Module (J519)

Relay Carrier on Vehicle Electrical System Control Module (J519)

• The relay carrier is clipped underneath the vehicle electrical system control module and can be replaced separately. The vehicle electrical system control module is clipped to a bracket in the driver footwell.

Removal

- Switch off the ignition and all electrical consumers and remove the ignition key.

- Remove the cover in the driver footwell.

- Remove the trim on the driver side.

- Press both latching mechanisms - arrows - and tilt the Vehicle electrical system control module (J519) slightly downward.






- Pull the vehicle electrical system control module downward and opposite the direction of travel and remove it from the bracket.

- Turn the vehicle electrical system control module while paying attention to the connected wires.

- Release both latching mechanisms - arrows - and remove the relay carrier - 1 - in the - direction of the arrow - from the vehicle electrical system control module - 2 -.






- Press the 2 release buttons on the back of the relay connector - arrows - inward and remove the relay connector - 1 - together with the relay from the relay carrier - 2 -.






- Perform this procedure consecutively at all available relays and then remove the relay carrier - 2 -.

Installation

Installation is performed in the reverse order of removal. Note the following:

• During installation, ensure secure latching of the relay connectors in the relay carrier and of the relay carrier on the vehicle electrical system control module.