Operation CHARM: Car repair manuals for everyone.

Piston and Connecting Rod Assembly Overview






Piston and Connecting Rod Assembly Overview





1 Piston Rings

• Offset the gaps by 120 degrees.

• Use piston ring pliers for removal and installation.

• Identification "TOP" faces towards the piston crown.

• Checking ring gap, refer to => [ Piston Ring Gap, Checking ] Testing and Inspection.

• Checking piston ring groove clearance, refer to => [ Piston Ring Groove Clearance, Checking ] Testing and Inspection.

2 Piston

• Checking, refer to => [ Pistons, Checking ] Testing and Inspection.

• Mark the installed location to the connecting rod and the affiliation to the cylinder.

• Flatter side of piston crown faces toward the center of the cylinder block.

• Installing piston, refer to => [ Piston, Installing ] Piston, Installing.

3 Circlip

4 Connecting Rod

• Only replace as a set.

• Affiliation to the cylinder mark - B -.

• Installation position: Markings - A - must align.

5 Bearing Shell

• Note the installation position.

• Do not interchange the used bearing shells.

• Bearing shell retaining tabs must be firmly seated in the notches.

• Axial clearance:

New: 0.05 to 0.31 mm

Wear limit: 0.40 mm

• Measure radial clearance with Plastigage:

New: 0.02 to 0.07 mm

Wear limit: 0.10 mm

• Do not turn the crankshaft when measuring radial play.

6 Connecting Rod Bearing Cap

• Affiliation to the cylinder mark - B -.

• Installation position: Markings - A - must align.

7 Bolt, 30 Nm + 90° (1/4) additional turn

• Always replace.

• Lubricate the threads and contact surface.

• Tighten to 30 Nm to measure the radial play, but do not turn further.

8 Cylinder Block

• Checking cylinder bore, refer to => [ Cylinder Bore, Checking ] Testing and Inspection.

• Crankshaft assembly overview, refer to => [ Crankshaft Assembly Overview ] Crankshaft Assembly Overview.

• Piston and cylinder dimensions, refer to => [ Piston and Cylinder Dimensions ] Piston and Cylinder Dimensions.

9 Piston Pin

• If difficult to move, heat the piston to 60 °C (140 °F).

• Remove and install using a pilot drift (VW 222A ).