Cylinder Block Components, Rear

Cylinder Block Components, Rear





1 Cylinder Block

2 Locking Bolt, 30 Nm

• With a rolled up seal.

• The bore in the cylinder block is used for securing the crankshaft using the locking pin (T40069).

3 Bolt, 25 Nm

4 Brace

• For the exhaust manifold.

5 Knock Sensor (KS) 1 (G61)

• Note the installed position: Wire connection points downward vertically.

6 Bolt, 20 Nm

• Tightening specification affects the function of the KS.

7 Bolt 10 Nm

8 Shield

9 Bayonet Connection

10 Wire Clip

• Clipped to the shield.

11 Knock Sensor (KS) 2 (G66)

• Note the installed position: Wire connection points 45° toward the outside right.

12 Wire Bracket

• Bolted to the Secondary Air Injection (AIR) valve.

13 Connector

• Green for the KS 1.

• Installed location, refer to => [ Installed Position of Harness Connectors for the Knock Sensors ].

• Contacts are gold plated.

14 Connector

• Gray for the KS 2.

• Installed location, refer to => [ Installed Position of Harness Connectors for the Knock Sensors ].

• Contacts are gold plated.

15 Bolt, 10 Nm

Installed Position of Harness Connectors for the Knock Sensors





1. Green for the KS 1

2. Gray for the KS 2