Operation CHARM: Car repair manuals for everyone.

Reassembly





HEATING / AIR CONDITIONING: AIR CONDITIONING UNIT (for Sedan): REASSEMBLY

1. INSTALL NO. 1 COOLER THERMISTOR Installation

2. INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY





HINT
If a new cooler evaporator is installed, add compressor oil to the cooler evaporator as follows.

Compressor oil:

ND-OIL8 or the equivalent. Add 40 cc (1.35 fl. oz.)

(a) Install the cooler evaporator.

(b) Engage the 4 claws and install the heater case lower.





(c) Install the 3 screws.

(d) Engage the cooler thermistor connector.





3. INSTALL COOLER EXPANSION VALVE





(a) Apply sufficient compressor oil (ND-OIL8) to 2 new O-rings and the fitting surface of the cooler expansion valve.

Compressor oil:

ND-OIL8 or the equivalent

(b) Install the 2 O-rings onto the cooler evaporator.

(c) Using a hexagon wrench 4, install the cooler expansion valve with the 2 hexagon bolts.

Torque : 3.5 Nm (36 kgf-cm, 31 in-lbf)

4. INSTALL HEATER RADIATOR UNIT SUB-ASSEMBLY





(a) Install the heater radiator unit onto the air conditioner radiator assembly.

(b) Engage the 3 clips and install the clamp.





5. INSTALL NO. 2 AIR DUCT





(a) Engage the 3 claws and install the air duct.

6. INSTALL NO. 1 AIR DUCT





(a) Engage the 3 claws and install the air duct.

7. INSTALL AIR MIX DAMPER CONTROL CABLE SUB-ASSEMBLY





(a) Engage the claw and install the air mix damper control cable.

8. INSTALL DEFROSTER DAMPER CONTROL CABLE SUB-ASSEMBLY





(a) Engage the claw and install the defroster damper control cable.