Open in One Side Of CAN Branch Line
CAN COMMUNICATION: CAN COMMUNICATION SYSTEM: Open in One Side of CAN Branch Line
- Open in One Side of CAN Branch Line
DESCRIPTION
If 2 or more ECUs and/or sensors do not appear on the intelligent tester "BUS CHECK" screen via the CAN VIM, one side of the CAN branch wire may be open. (one side of the CAN-H [branch wire] / CANL [branch wire] of the ECU and/or sensor is open.)
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
* Turn the ignition switch off before measuring the resistances of the CAN main wire and the CAN branch wire.
* After the ignition switch is turned off, check that the key reminder warning system and light reminder warning system are not in operation.
* Before measuring the resistance, leave the vehicle for at least 1 minute and do not operate the ignition switch, any switches or doors. If doors need to be opened in order to check connectors, open the doors and leave them open.
HINT
Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.
HINT
* The following is the troubleshooting procedure of an open in either CANH or CANL of the ECU A (SENSOR A).
* Perform the following inspection for the ECUs (sensors) which are not displayed on the intelligent tester. If malfunction cannot be identified, then perform the following inspections for the ECUs (sensors) connected to CAN communication.
PROCEDURE
1. CHECK FOR OPEN ONE SIDE OF CAN BRANCH WIRE
(a) Turn the ignition switch OFF.
(b) Disconnect the connector with terminals CANH and CANL of the ECU A (SENSOR A).
(c) Turn the ignition switch ON.
(d) Select "Check the ECU connected to CAN BUS" on the intelligent tester.
Result:
B -- CONNECT ECU A CONNECTOR AND INSPECT OTHER ECUS / SENSORS TO MEET "STANDARD A"
A -- Continue to next step.
2. CHECK FOR OPEN ONE SIDE OF CAN BRANCH WIRE
(a) Turn the ignition switch OFF.
(b) Disconnect the connector with terminals CANH and CANL of the ECU A (SENSOR A).
(c) Measure the resistance.
Standard resistance:
NG -- REPAIR OR REPLACE ECU A BRANCH WIRE OR CONNECTOR
OK -- REPLACE ECU A (SENSOR A)