Operation CHARM: Car repair manuals for everyone.

Initial Inspection and Diagnostic Overview

SPARK TEST

NOTE: Perform this test to check that voltage is coming from the distributor.

1. CONNECT TIMING LIGHT TO EACH SPARK PLUG.
2. CRANK ENGINE AND CHECK THAT LIGHT FLASHES: If the timing light does not flash, check wiring connections, ignition coil, igniter, distributor, ECU or ignition switch.

INSPECTION OF HIGH TENSION CORD




1. CAREFULLY REMOVE HIGH TENSION CORDS BY RUBBER BOOT.

CAUTION: DO NOT pull on the cords or bend the wires. The conductor inside may be damaged.




2. INSPECT CORD TERMINALS: Check the terminals for corrosion, breaks or distortion. Replace wire as required.
3. CHECK WIRE RESISTANCE: Using an ohmmeter, check that the resistance does not exceed the maximum. Replace the cord as required. Maximum resistance: 25 k ohms per cord.

INSPECTION OF SPARK PLUG (Platinum Tipped Spark Plug)

CAUTION:
^ NEVER USE WIRE BRUSH FOR CLEANING.
^ NEVER ATTEMPT TO ADJUST GAP ON USED PLUG.
^ SPARK PLUGS SHOULD BE REPLACED EVERY 60,000 miles (100,000 km).




1. INSPECT ELECTRODE.
a. If using a megger (insulation resistance meter). Measure the insulation resistance. Correct insulation resistance: More than 10 M ohms If less than 10 M ohms, clean the plug.
b. If not using a megger. Quickly race the engine to 4,000 rpm five times. Visually inspect the spark plugs. If the electrode is dry Okay, If the electrode is wet Clean the plug.
2. REMOVE SPARK PLUGS.
3. VISUALLY INSPECT SPARK PLUGS: Inspect the spark plugs for thread or insulator damage. If defective, replace the plug. Spark plug: ND P16R NGK BPR5EP11.
4. INSPECT ELECTRODE GAP: Maximum limit: 1.4 mm (0.055 in.) If limit is exceeded, replace the plug. Correct electrode gap of new plug: 1.0 - 1.1 mm (0.039-0.043 in.) If adjusting the gap of a new plug, bend only the base of the ground electrode, do not touch the tip.
5. CLEAN SPARK PLUGS: If the electrode has traces of wet carbon, allow it to dry and then clean with a spark plug cleaner. Air pressure: Bellow 6 kglcm2 (85 psi). Duration: 20 seconds or less.

NOTE: If there are traces of oil, clean it off with gasoline before using the spark plug cleaner.

6. INSTALL SPARK PLUGS: Torque: 200 - 300 kg-cm (15 - 21 ft-lb).