Inspection Procedure H-9
Headlight, Taillight: Headlight automatic shutdown function does not work normally.NOTE: This troubleshooting procedure requires the use of scan tool MB991502 and SWS monitor kit MB991862. For details on how to use the SWS monitor, refer to "How to use SWS monitor."
Headlight Automatic Shut-down Function:
CIRCUIT OPERATION
The ETACS-ECU operates the headlight automatic shutdown function according to the following signals:
- Ignition switch(IG1): OFF
- Driver's door switch: ON
- Taillight switch: ON
- Headlight switch: ON
The ETACS-ECU operates the headlight automatic shutdown function under the following conditions:
- Ignition key: Other than "ON" position
- Driver's door: open
- Taillight or headlight: Illuminating
TECHNICAL DESCRIPTION (COMMENT)
If the function does not work normally, the input circuit system from the switches, the ETACS-ECU or the front-ECU may be defective (refer to "CIRCUIT OPERATION").
TROUBLESHOOTING HINTS
- The driver's door switch may be defective
- The column switch may be defective (turn-signal light and lighting switch)
- The ETACS-ECU may be defective
- The front-ECU may be defective
- The wiring harness or connectors may have loose, corroded, or damaged terminals, or terminals pushed back in the connector
DIAGNOSIS
Required Special Tools:
- MB991223: Harness Set
- MB991502: Scan Tool (MUT-II)
- MB991862: SWS monitor kit
Check the input signal by using "DATA LIST" menu of the SWS monitor.
Check the input signals from the following switches:
- Ignition switch: "ON" to "OFF"
- Lighting switch: "TAIL' or "HEAD"
CAUTION:
To prevent damage to scan tool MB991502, always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool MB991502. Connect the DLC harness before connecting the column-ECU harness. Be sure to connect SWS monitor kit MB991862 after turning on scan tool MB991502.
1. Connect scan tool MB991502 to the data link connector.
2. Connect SWS monitor kit MB991862 to the column switch connector.
3. Operate scan tool MB991502 according to the procedure below to display "H/L AUTO-CUT."
1. Select "SYSTEM SELECT."
2. Select "SWS."
3. Select "SWS MONITOR."
4. Select "FUNCTION DIAG."
5. Select "LIGHTING."
6. Select "H/L AUTO-CUT"
4. Check that normal conditions are displayed on the items described in the table.
5. When the driver's door is opened, check that normal conditions are displayed on the items described in the table.
Q: Does the scan tool display the items "TAILLIGHT SW", "IG SW IG1", "FRONT DOOR SW" and "H/L AUTO-CUT" as normal condition?
YES: Replace the front-ECU. Verify that the headlight automatic shutdown function works normally.
NO:
- Normal condition is not displayed for "TAILLIGHT SW": Refer to Inspection Procedure M-5 "ETACS-ECU does not receive any signal from the taillight switch."
- Normal condition is not displayed for "IG SW (IG1)": Refer to Inspection Procedure M-2 "ETACS-ECU does not receive any signal from the ignition switch (IG1)."
- Normal condition is not displayed for "FRONT DOOR SW": Refer to Inspection Procedure M-4 "ETACS-ECU does not receive any signal from the driver's or the front passenger's door switch ."
- Normal condition is not displayed for "H/L AUTO-CUT": Replace the front-ECU. Check that the headlight automatic shutdown function works normally.