Operation CHARM: Car repair manuals for everyone.

Inspection Procedure E-4

Keyless Entry System: The dome light, the turn-signal lights and the horn do not operate through the answerback function.

CIRCUIT OPERATION
The ETACS-ECU operates the following functions when it receives lock or unlock signal from the transmitter:
- Dome light answerback function
- Turn-signal light answerback function
- Horn answerback function

TECHNICAL DESCRIPTION (COMMENT)
The turn-signal lights and horn answerback functions can be disabled or enabled. However, the dome light answerback function can not be disabled.

TROUBLESHOOTING HINTS
- The turn-signal light may be defective
- The theft-alarm horn may be defective
- The horn may be defective
- The dome light may be defective
- The ETACS-ECU may be defective
- The wiring harness or connectors may have loose, corroded, or damaged terminals, or terminals pushed back in the connector

DIAGNOSIS

Required Special Tools:
- MB991223: Harness Set
- MB991502: Scan Tool (MUT-II)

STEP 1. Check the keyless entry system.

Q: Does the keyless entry system work normally?

YES: Go to Step 2.

NO: Refer to Inspection Procedure E-1 "None of the doors are locked/unlocked and the trunk lid opener is not operated by the keyless entry transmitter."

STEP 2. Check the answerback adjustment function.

Check the answerback functions. Refer to Keyless Entry System - On-vehicle Service - Enabling/disabling the Answerback Function.)

Q: Does the answerback function work normally?

YES: No action is necessary and testing is complete.

NO: Go to Step 3.

STEP 3. Retest the system.

Q: Which answerback function is defective?
Only the dome light : Go to Step 4.
Only the turn-signal lights : Go to Step 5.
Only the horns : Go to Step 6.
None of the dome light, the turn-signal lights, and the horn : Replace the ETACS-ECU. Verify that the answerback functions work normally.

STEP 4. Check the dome light.

Q: Does the dome light illuminate normally?

YES: Replace the ETACS-ECU. Verify that the answerback functions work normally.

NO: Refer to Inspection Procedure K-1 "Dome light does not illuminate."

STEP 5. Check the hazard warning light.

Q: Do the hazard warning lights work normally?

YES: Replace the ETACS-ECU. Verify that the answerback functions work normally.

NO: Refer to Inspection Procedure I-2 "Hazard warning lights do not flash when the hazard warning light switch is turned on."

STEP 6. Check the theft-alarm system (horn).

Q: Does the theft-alarm system work normally?

YES: Replace the ETACS-ECU. Verify that the answerback functions work normally.

NO: Refer to Inspection Procedure L-2 "Tone alarm does not sound when the theft-alarm system is triggered."