Operation CHARM: Car repair manuals for everyone.

Inspection Procedure C-5

Central Door Locking System: All the doors do not lock or unlock with just the driver's or front passenger's inside lock knob operation.

Central Door Lock (Door Lock Actuator Switch) Circuit:






TECHNICAL DESCRIPTION
The driver's or front passenger's door lock actuator switch or the ETACS-ECU may be defective.

TROUBLESHOOTING HINTS
- The driver's or front passenger's door lock actuator switch may be defective
- The ETACS-ECU may be defective
- The wiring harness or connectors may have loose, corroded, or damaged terminals, or terminals pushed back in the connector

DIAGNOSIS

Required Special Tools:
- MB991223: Harness Set
- MB991502: Scan Tool (MUT-II)




Check the input signal by using the pulse check mode of the monitor.

Check the input signals from the driver's or front passenger's door lock actuator switch.

CAUTION: To prevent damage to scan tool MB991502, always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool MB991502.

1. Connect scan tool MB991502 to the data link connector.
2. When the driver's inside lock knob is locked or unlocked, check if scan tool MB991502 sounds or not.
3. Operate scan tool MB991502 according to the procedure below to display "PULSE CHECK."
1. Select "SYSTEM SELECT."
2. Select "SWS."
3. Select "PULSE CHECK."

Q: Does scan tool MB991502 sound when the driver's or the front passenger's inside lock knob is moved from "LOCK" to "UNLOCK" or vice versa?

YES: Replace the ETACS-ECU. Check that all the doors can be locked or unlocked by operating the driver's inside lock knob.

NO: Refer to Inspection Procedure N-6 "ETACS-ECU does not receive any signal from the driver's or front passenger's door lock actuator switch".