Operation CHARM: Car repair manuals for everyone.

Inspection Procedure C-4

Central Door Locking System: All the doors do not lock or unlock with just the door lock key cylinder key operation.

Central Door Lock (Door Lock Actuator Switch) Circuit:






TECHNICAL DESCRIPTION (COMMENT)
The door lock switch (built into the power window switch) or the ETACS-ECU may be defective.

TROUBLESHOOTING HINTS
- The power window switch (door lock switch) may be defective
- The ETACS-ECU may be defective
- The wiring harness or connectors may have loose, corroded, or damaged terminals, or terminals pushed back in the connector

DIAGNOSIS

Required Special Tools:
- MB991223: Harness Set
- MB991502: Scan Tool (MUT-II)




Check the input signal by using the pulse check mode of the monitor.

Check the input signals from the door lock key cylinder switch.

CAUTION: To prevent damage to scan tool MB991502, always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool MB991502.

1. Connect scan tool MB991502 to the data link connector.
2. When the doors are locked and unlocked by using the driver's or front passenger's door lock key cylinder, check that scan tool MB991502 sounds.
3. Operate scan tool MB991502 according to the procedure below to display "PULSE CHECK."
1. Select "SYSTEM SELECT."
2. Select "SWS."
3. Select "PULSE CHECK."

Q: When the doors are locked and unlocked by using the driver's or front passenger's door lock key cylinder, does scan tool MB991502 sound?

YES: Replace the ETACS-ECU. Check that all the doors should be locked and unlocked by using each door lock key cylinder switch.

NO: Refer to Inspection Procedure N-5 "ETACS-ECU does not receive any signal from the driver's door, front passenger's door lock key cylinder switch."