Inspection Procedure C-3
Central Door Locking System: All the doors do not lock or unlock with just the door lock switch operation.Central Door Lock (Door Lock Key Cylinder Switch) Circuit:
TECHNICAL DESCRIPTION (COMMENT)
The door lock switch (built into the power window switch) or the ETACS-ECU may be defective.
TROUBLESHOOTING HINTS
-The power window switch (door lock switch) may be defective
-The ETACS-ECU may be defective
-The wiring harness or connectors may have loose, corroded, or damaged terminals, or terminals pushed back in the connector
DIAGNOSIS
Required Special Tools:
- MB991223: Harness Set
- MB991502: Scan Tool (MUT-II)
Check the input signal by using the pulse check mode of the monitor.
Check the input signals from the door lock switch:
CAUTION:
To prevent damage to scan tool MB991502, always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool MB991502.
1. Connect scan tool MB991502 to the data link connector.
2. When the driver's or the front passenger's door lock switch is moved from "LOCK" to "UNLOCK" and vice versa, check if scan tool MB991502 sounds or not.
3. Operate scan tool MB991502 according to the procedure below to display "PULSE CHECK."
1. Select "SYSTEM SELECT."
2. Select "SWS."
3. Select "PULSE CHECK."
Q: Does scan tool MB991502 sound when the driver's or the front passenger's door lock switch is moved from "LOCK" to "UNLOCK" and vice versa?
YES: Replace the ETACS-ECU. Check that all the doors should be locked and unlocked by the door lock switch.
NO: Refer to Inspection Procedure N-7 "ETACS-ECU does not receive any signal from the door lock switch (incorporated in the power window main switch)".