Operation CHARM: Car repair manuals for everyone.

Flow Chart No. 2: No Power to Servo Assembly

Flow Chart No. 2 - Symptom - No power to servo.

Step 1
Check ignition circuit.
1. Make sure Step 1 in Flow Chart No. 1 has been done.




2. With ignition switch in the RUN position, measure the voltage between Pin 7 (GY/Y) and ground point on the chassis.




3. Is battery voltage present?

Step 2
Check module ground circuit.




1. With ignition switch in OFF position, measure the resistance between Pin 10 (P/O) and ground point on the chassis.




2. Is resistance less than 1 ohm?