Operation CHARM: Car repair manuals for everyone.

12 Backfires-Idle/Acceleration/Deceleration

DESCRIPTION
Sound produced from exhaust system

1. Is the pass diagnostic trouble code displayed during Key On Engine Off inspection and Key On Engine Running inspection?

Yes - Pass diagnostic trouble code displayed. Go to next step.
No - Diagnostic trouble code no. displayed or no diagnostic trouble codes displayed Check for cause

2. Disconnect the in-line SPOUT connector. Is base timing within specification at idle?

Base timing: BTDC 10 ± 2°

Yes - Go to next step
No - Adjust base timing. If not adjustable, check as follows:
- Camshaft Position Sensor
- Timing belt
- Crankshaft Position Sensor

3. Is a strong blue spark visible at each disconnected high-tension lead while cranking engine?

Yes - Check spark plugs
- If OK, go to next step
- If not OK, clean or replace spark plug
No - Check as follows:
- Camshaft Position Sensor
- High-tension leads
- Ignition Control Module
- Crankshaft Position Sensor

4. Perform Cylinder Balance Test. Are there any diagnostic trouble codes?

Yes - Check resistance of injector(s) at PCM connector. If resistance is OK, check as follows:
- Injector drive signal
- If resistance is not OK, check as follows:
- Open/short circuit in injector circuit
No - Go to next step

5. Is engine compression correct?

Yes - Go to next step
No - Check for cause

6. Is there a restriction in the exhaust system?

Yes - Check exhaust system
No - Go to next step

7. Start engine and run it at idle. Measure fuel line pressure at idle. Is fuel line pressure correct at idle?

Fuel line pressure: 210 - 310 kPa (30 - 45 psi)

Yes - Go to next step
No - Low:
- Check pressure regulator diaphragm
- Check fuel pump
- High:
- Check pressure regulator for high pressure cause
- Check for clogged fuel return line

8. Connect a jumper wire between FP terminal of data link connector and a ground. Does fuel line pressure remain at specification for 60 seconds when ignition switch is turned ON?

Yes - Go to next step
No - Check pressure regulator diaphragm

9. Verify test results. If OK, return to diagnostic index to service any additional symptoms. Symptom Index