Reading Diagnostic Trouble Codes
If the MIL (Malfunction Indicator Lamp) has come on1. Start the engine and check the MIL.
2. If the MIL stays on, connect the Honda PGM Tester (A) to the 16P Data Link Connector (B) located under the driver's side of the dashboard.
3. Turn the ignition switch ON (II).
4. Check the DTC and note it. Also check the freeze frame data. Refer to the Diagnostic Trouble Code Chart and begin the appropriate troubleshooting procedure.
NOTE:
- Freeze frame data indicates the engine conditions when the first malfunction, misfire or fuel trim malfunction was detected.
- The Honda PGM tester can read the Diagnostic Trouble Codes (DTC), freeze frame data, current data, and other Powertrain Control Module (PCM) data.
- For specific operations, refer to the user's manual that came with the PGM tester.
If the MIL did not come on
If the MIL did not come on but there is a driveablity problem, refer to the Symptom Troubleshooting Index.
If you can't duplicate the DTC
Some of the troubleshooting requires you to reset the Powertrain Control Module (PCM) and try to duplicate the Diagnostic Trouble Code (DTC). If the problem is intermittent and you can't duplicate the code, do not continue through the procedure. To do so will only result in confusion and, possibly, a needlessly replaced PCM.