Housing Assembly HVAC: Service and Repair
HVAC MODULE ASSEMBLY REPLACEMENTREMOVAL PROCEDURE
CAUTION: Refer to Battery Disconnect Caution in Service Precautions.
1. Disconnect the negative battery cable.
2. Remove the instrument panel assembly.
3. Remove the instrument panel reinforcement.
4. Disconnect the blower motor electrical connector.
5. Disconnect the blower motor resistor electrical connector (4).
6. Disconnect the A/C compressor control module electrical connector (1).
7. Drain the Cooling System. Refer to Draining and Filling Cooling System in Cooling System.
8. Remove the heater hoses (1,2) at the heater core.
9. Discharge and recover the Refrigerant. Refer to Refrigerant Recovery and Recharging. Service and Repair
10. Remove the cruise control servo (if equipped).
IMPORTANT: Cap the open fittings in order to prevent dirt and moisture from entering the refrigeration system.
11. Remove the evaporator inlet (2) and outlet (1) tubes from the evaporator.
12. Separate the rear heater ducts (1) from the HVAC module assembly.
13. Remove the six nuts.
14. Pull the HVAC module assembly forward and remove from the vehicle.
INSTALLATION PROCEDURE
1. Install the HVAC module assembly to the vehicle.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the six nuts.
Tighten
Tighten the nuts to 10 N.m (89 lb in).
3. Connect the rear heater ducts (1) to the HVAC module assembly.
4. Install new O-rings lubricated with mineral base 525 viscosity refrigerant oil.
5. Install the evaporator inlet (2) and outlet (1) tubes to the evaporator.
Tighten
^ Tighten the inlet tube (2) to 25 N.m (19 lb ft).
^ Tighten the outlet hose (1) to 38 N.m (28 lb ft).
6. Connect the A/C compressor control module electrical connector (1).
7. Connect the blower motor resistor electrical connector (4).
8. Connect the blower motor electrical connector.
9. Install the instrument panel reinforcement.
10. Install the instrument panel assembly.
11. Install the heater hoses (1,2) to the heater core.
12. Fill the cooling system.
13. Evacuate and Recharge the A/C system. Refer to Refrigerant Recovery and Recharging. Service and Repair
14. Install the cruise control servo (if removed).
15. Connect the negative battery cable.
Tighten
Tighten the negative battery cable to 15 N.m (11 lb ft).
16. Operate the A/C system and test for refrigerant leaks. Refer to Leak Testing. Leak Testing