Housing Assembly HVAC: Service and Repair
HVAC MODULE ASSEMBLY REPLACEMENT
TOOLS REQUIRED
- J 37097-A Heater Hose Clamp Tool
- J 38185 Hose Clamp Pliers
- J 39400-A Halogen Leak Detector
REMOVAL PROCEDURE
1. Recover the refrigerant. Refer to Refrigerant Recovery and Recharging.
2. Drain the engine coolant. Refer to Draining and Filling Cooling System in Cooling System.
3. Remove the evaporator hose nut from the evaporator.
4. Remove the evaporator hose and the accumulator tube from the evaporator.
5. Remove and discard the O-rings from the evaporator hose and accumulator tube.
6. Remove the heater hoses from the heater core using the J 37097-A.
7. Plug the heater core and evaporator core openings to prevent leaking into the vehicle when removing the HVAC module assembly.
8. Remove the instrument panel (I/P) assembly.
9. Remove the defroster duct screws.
10. Remove the defroster duct.
11. Disconnect the blower control module (1) electrical connector.
12. Disconnect the instrument panel to HVAC harness connector.
13. Remove the HVAC module retaining nuts (1-5) from the I/P.
14. Remove the HVAC module from the vehicle.
INSTALLATION PROCEDURE
1. Install the HVAC module to the vehicle.
2. Install the HVAC module nuts to the I/P (1-5).
Tighten the nuts to 9 N.m (80 lb in).
NOTE: Refer to Fastener Notice in Service Precautions.
3. Connect the electrical connector to the blower control module (1).
4. Connect the I/P to HVAC module electrical connector.
5. Install the defroster duct.
6. Install the defroster duct screws.
Tighten the screws to 2.5 N.m (23 lb in).
7. Install the defroster duct to front of dash mounting nut.
Tighten the nut to 9 N.m (65 lb in).
8. Install the I/P assembly.
9. Connect the heater hoses to the heater core using the J 38185.
10. Install the new O-rings to the evaporator hose and the accumulator tube.
11. Install the evaporator hose and the accumulator tube to the evaporator.
12. Install the evaporator hose nut to the evaporator.
Tighten the nut to 24 N.m (18 lb ft).
13. Evacuate and recharge the air conditioning (A/C) system. Refer to Refrigerant Recovery and Recharging.
14. Leak test the fittings of the A/C component using the J 39400-A.
15. Fill the engine cooling system. Refer to Draining and Filling Cooling System in Cooling System.