Denso A/C Compressor Belt Pulley - Version 2 Overview

Denso A/C Compressor Belt Pulley - Version 2 Overview






1 Screw

• Replace

• 20 Nm

2 Drive Plate

• Different versions, refer to Electronic Parts Catalog.

• Removing and installing, refer to => [ Denso A/C Compressor Belt Pulley - Version 2 ] Denso A/C Compressor Belt Pulley - Version 2.

• The overload protection takes over when the torque is excessive (for example, if the A/C compressor runs with resistance) and the belt pulley runs freely without driving the A/C compressor.

3 Circlip

• Replace

• Install on the correct side - flat side toward the A/C compressor.

4 Belt Pulley

• Different versions, refer to Electronic Parts Catalog.

• Removing and installing, refer to => [ Denso A/C Compressor Belt Pulley - Version 2 ] Denso A/C Compressor Belt Pulley - Version 2.

• The rubber element on the belt pulley disengages in the case of an excessive torque (for example, if the A/C compressor runs with resistance) and the belt pulley runs freely without driving the A/C compressor.

• Under certain conditions (such as rough engine idle), the rubber element of the belt pulley can disengage without a malfunction at the A/C compressor or in the refrigerant circuit.

5 A/C Compressor

• Clean the A/C compressor input shaft before sliding on the belt pulley.