Intake Manifold Overview

Intake Manifold Overview






1 - Intake Air Temperature (IAT) Sensor (G42) Bolt

• 9 Nm

2 - IAT Sensor (G42)

- Evaporative Emission (EVAP) Canister Purge Regulator Valve 1 (N80)

• With double check-valve, checking, refer to => [ Double Check-Valve, Checking ] Testing and Inspection

4 - Intake Manifold

• 10 Nm

• Removing and installing engine code CAEB, refer to => [ Intake Manifold ] Intake Manifold

• Removing and installing, hybrid vehicles, engine code CHJA, refer to => [ Intake Manifold ] Intake Manifold

5 - Channel Separating Plate Vacuum Diaphragm (intake manifold flaps)

6 - Intake Manifold Runner Control (IMRC) Valve (N316)

7 - Fuel Injectors

• Replace the O-ring and Teflon(R) ring

• Note correct installation position

• Removing and installing, refer to => [ Fuel Injectors ] Fuel Injectors

8 - Intake Manifold Support

9 - Intake Manifold Support Bolt

• 23 Nm

10 - Intake Manifold Support Nut

• 10 Nm

11 - Throttle Valve Control Module (J338) Bolts

• 9 Nm

12 - Throttle Valve Control Module (J338) , Electronic Power Control (EPC) Throttle Drive (G186) ,

• EPC throttle drive angle sensor 1 (G187) and EPC throttle drive angle sensor 2 (G188)

• After removing, installing or replacing the throttle valve control module , adapt it again to the Engine Control Module (ECM) (J623). Refer to "Guided Functions", and use a vehicle diagnostic tester to carry this out.

13 - Seal

• Replace