Selector Mechanism Function Unit, Manual Release Overview

Selector Mechanism Function Unit, Manual Release Overview

• Coat the bearings and the sliding surfaces with polycarbamide grease (G 052 142 A2).





1 Selector Lever Cable Rubber Boot

• Make sure the selector lever cable rubber boot is engaged correctly in the shift mechanism shift unit.

• In case of damaged rubber boot, selector lever cable must be replaced

2 Securing Plate

• For selector lever cable to shift mechanism function unit

• Installed position: The angled end faces up

3 Selector Lever Cable

• Refer to => [ Selector Lever Cable Overview ] Selector Lever Cable Overview

4 Bracket

• With manual release rocker switch

• There are different versions

5 Nut

• 8 Nm

6 Bolt

• 3.5 Nm

7 Manual Release Actuator Cable

• Removing and installing, refer to => [ Emergency Release Operating Mechanism ] Emergency Release Operating Mechanism

8 Electric Connector

• For shift lock solenoid (N110) and transmission park selector switch (F305)

9 Selector Mechanism Function Unit

• For shift lock solenoid and transmission park selector switch

• Can only be replaced as a unit

• Removing and installing, refer to => [ Shift Mechanism and Selector Lever Cable ] Shift Mechanism and Selector Lever Cable

10 Nut

• 8 Nm

11 Selector Mechanism Shift Unit

• With affixed gasket

12 Sound Proofing

13 Circlip

• For sound proofing on shift activator

• Removing and installing

14 Bolt

• 1.5 Nm